-
Also commonly known as a duckbill, this unit bolts to pipe to keep gate open. Please see additional information below for further details
-
Malleable gate rest. Please see additional information below for further details
-
Malleable hub with malleable steel wheel for 2 1/2“ gate, having needle bearings and grease fittings. Has 1 1/8” shaft axle. This unit works very well with automatic openers. *Deluxe rollers have needle bearings. Please see additional information below for further details
-
Available in sizes that our deluxe unit is not available in. Hub is pressed steel with 4 – ½” x 2 ½” carriage bolts. Comes with 1 1/8” shaft and grease fitting. * Deluxe rollers have needle bearings. Please see additional information below for further details
-
Top of the line cantilever roller using 1" shaft and graphite nylon wheels. This works very well with high usage gate operator systems. Can also be adapted for square gate frames. Please see additional information below for further details
-
Poly guards designed to fit over cantilever rollers for safety. Please see additional information below for further details
-
6" x 2" wide wheel designed for double front trucks using embedded angle channel for tracking of gates. Can be purchased installed on double front trucks. Call for availability. Please see additional information below for further details
-
Cast aluminum caps for sealing pipe to prevent corrosion. Please see additional information below for further details
-
Plugs designed for drive-in fitting. Please see additional information below for further details
-
Plain, one way, and two-way caps designed to finish fence installations. Designed to accept standard top rail where needed. Concave adapters used to attach top rails by bolting on either side of smooth bullet tops to make 1-way or 2-way bullet tops. Please see additional information below for further details
-
Loop caps designed for either 1 3/8” or 1 5/8” top rails. Please see additional information below for further details
-
Offset rail end brackets designed to stop top rails. To be used with brace bands. Please see additional information below for further details
-
Solid corner for a clean corner on gate assemblies. Also available in split design. Please see additional information below for further details
-
Spring loaded closure designed to work in either direction. Please see additional information below for further details
-
Galvanized bands designed for square tubing. Designed to pull fabric and attach to square tubing. 13 gauge x 7/8” for strength. Please see additional information below for further details
-
11 gauge Square Line Rail Clamps are a two-piece clamp designed for 180° horizontal square rail connections to a square line post. Carriage bolt and nut sold separately. Please see additional information for further details
