-
14 gauge steel-ell bracket with 9 gauge strap with set screw. Designed to screw onto wood rail and be supported by steel fence post. Very popular item to run wood fencing using steel posts. Please see additional information below for further details
-
Heavy 3/16” x 2” steel bracket with 9 gauge hinge strap designed to be used with carriage bolt to tighten strap using 3/8” x 3 1/2" bolt (not included). Please see additional information below for further details
-
Heavy 3/16” x 2” bracket with 9 gauge strap with set screws. Differs from above due to thicker steel and no lip; so can be mounted anywhere on flat surface. Please see additional information below for further details
-
Male post hinges made in 8 gauge galvanized steel and have 5/8" pins. Heavy male hinge uses 3" x 5" plate for attachment. Please see additional information below for further details
-
Available in sizes that our deluxe unit is not available in. Hub is pressed steel with 4 – ½” x 2 ½” carriage bolts. Comes with 1 1/8” shaft and grease fitting. * Deluxe rollers have needle bearings. Please see additional information below for further details
-
90º hinge assembly designed to fit 1 5/8” or 1 7/8” gate frame. Please see additional information below for further details
-
Bracket designed for baseball backstops allowing angled top pipes for containment. Please see additional information below for further details
-
One piece corner arms designed for 3-wire barb standoffs made from malleable steel. Please see additional information below for further details
-
Available in many sizes and attaches with a bent bolt. Very popular clean looking installation. Please see additional information below for further details
-
One-piece base with open bottom with four-corner bolt flange. Also has set screws for pipe security. Please see additional information below for further details
-
Malleable gate rest. Please see additional information below for further details
-
Also commonly known as a duckbill, this unit bolts to pipe to keep gate open. Please see additional information below for further details
-
Heavy 3/16” x 2” steel bracket with 9 gauge strap with set screw. Similar to inside corner wood fence adapter but to be used for outside installation. Does not have lip, so it can be mounted on any flat surface. Please see additional information below for further details
-
Panel clamps are a two-piece clamp designed to secure prefabricated panels on freestanding enclosures. These clamps are made from 8 gauge x 1 1/2" wide steel with approximately 1/2" spacing between the two pieces of tubing. Carriage bolt and nut sold separately. Please see additional information for further details
-
12 gauge x 3/4" 2 piece strap steel clamp designed to join two pipes at 90º angles. Used mainly in the construction of greenhouses, but can also be used to build portable buildings and for many other uses. Strap steel which is twisted and galvanized, are sold without bolts. Please see additional information below for further details
-
Steel bracket to attach a round post to the side of a wall. Please see additional information below for further details
