-
Gate collars are attached to a gate fork and post with carriage bolts to form a gate latch assembly. The collars are made of 8 gauge steel and come in three sizes to fit various post sizes such as: 1 3/8" 1 5/8" 1 7/8" Please see additional information below for further details
-
A gate fitting used to hold a gate in place when closed. Used on 1 3/8” gate frame with two fork sizes of 1 7/8" & 2 3/8". Has padlock hole under latch to secure gate. Please see additional information below for further details
-
Pressed steel barbed wire corner arms are a post fitting used to hold barbed wire in place. These arms are angled at 45º and hold three strands of barbed wire. Please see additional information for further details
-
Post hinges are a fitting that attaches to the gatepost, the pintle of which fits the frame hinge permitting the gate to swing. These hinges are made from 8 gauge x 1 1/4" wide or 8 gauge x 1 1/2" wide steel. A 3/8" x 2" through 3 1/2" carriage bolt and nut are used. Carriage bolt and nut sold separately. Please see additional information below for further details
-
Steel bracket to attach a round post to the side of a wall. Please see additional information below for further details
-
12 gauge x 3/4" 2 piece strap steel clamp designed to join two pipes at 90º angles. Used mainly in the construction of greenhouses, but can also be used to build portable buildings and for many other uses. Strap steel which is twisted and galvanized, are sold without bolts. Please see additional information below for further details
-
Panel clamps are a two-piece clamp designed to secure prefabricated panels on freestanding enclosures. These clamps are made from 8 gauge x 1 1/2" wide steel with approximately 1/2" spacing between the two pieces of tubing. Carriage bolt and nut sold separately. Please see additional information for further details
-
Heavy 3/16” x 2” steel bracket with 9 gauge strap with set screw. Similar to inside corner wood fence adapter but to be used for outside installation. Does not have lip, so it can be mounted on any flat surface. Please see additional information below for further details
-
Also commonly known as a duckbill, this unit bolts to pipe to keep gate open. Please see additional information below for further details
-
Malleable gate rest. Please see additional information below for further details
-
One-piece base with open bottom with four-corner bolt flange. Also has set screws for pipe security. Please see additional information below for further details
-
Available in many sizes and attaches with a bent bolt. Very popular clean looking installation. Please see additional information below for further details
-
One piece corner arms designed for 3-wire barb standoffs made from malleable steel. Please see additional information below for further details
-
Bracket designed for baseball backstops allowing angled top pipes for containment. Please see additional information below for further details
-
90º hinge assembly designed to fit 1 5/8” or 1 7/8” gate frame. Please see additional information below for further details
-
Available in sizes that our deluxe unit is not available in. Hub is pressed steel with 4 – ½” x 2 ½” carriage bolts. Comes with 1 1/8” shaft and grease fitting. * Deluxe rollers have needle bearings. Please see additional information below for further details
